Jet Epoxy

Quick Overview

Jet Epoxy is a quick set 100% solids self leveling toughened epoxy. It provides excellent adhesive characteristics while exhibiting good chemical, moisture and UV resistance. It can be used as a primer or as a final top-coat. It may be used in confined areas as it emits very low odor emissions. This material is used on metal, wood, fiberglass, concrete, masonry and other difficult to coat surfaces requiring a tough exterior coating. It may also be formulated with anti-corrosion additives to protect ferrous metals from oxidation.

Jet Epoxy may be applied using pressure pot or air-less spray, roll-on or brush-on. This 2K epoxy system finishes glossy smooth when fully cured. This material is to be used directly on clean dry surfaces and becomes tack free within 1 hour depending on ambient humidity and temperature. It is an excellent primer backbone for all SuperSkinSystems’ super-polymers and general topcoats. It retains a wide functional temperature range while yielding good flexibility from 25F to 150F. Full cure is achieved under normal drying conditions in 24 hours.

Jet Epoxy is available in 3 primary formulations:
289: clear and fast
351: low temp fast cure
319: clear slow top coat

Please contact our technical support group for specific substrate application procedures, equipment, safety gear and clean-up kits. Refer to MSDS for material and safety standard procedures.